Similar Articles |
|
U.S. CPSC May 8, 2008 |
American Honda Motor Co. Recalls ATVs Due to Loss of Steering Control The electric power steering shaft of the recalled ATVs could break unexpectedly, resulting in the rider's losing steering control. This poses a risk of injury or death to riders. |
U.S. CPSC January 31, 2007 |
American Honda Motor Corp. Recalls All-Terrain Vehicles for Crash Hazard The front suspension arm ball joints could have been contaminated during production, resulting in rapid wear of one or more of the ball joints and possible ball joint separation. If the ball joint separation occurs while riding, the operator could lose control of the ATV. |
U.S. CPSC January 9, 2008 |
ATVs Recalled By American Honda Motor Co. Due to Loss of Speed Control Water can enter the throttle position sensor and freeze, causing permanent damage if the rider forces the throttle lever. This could cause the throttle to stick open, posing a risk of injury or death to riders. |
U.S. CPSC April 14, 2005 |
American Honda Motor Co. Recall of ATVs The steering rods can separate, causing the driver to lose steering control. This could cause the ATV to crash and pose a risk of serious injury or death. |
U.S. CPSC July 28, 2005 |
American Suzuki Motor Corp. Recall of ATVs A significant impact to the front wheel of the ATV while the steering is fully turned to either side can result in suspension damage, wear, and an eventual loss of steering control that could result in injury or death. |
U.S. CPSC December 14, 2005 |
American Honda Motor Corp. Recall of All-Terrain Vehicles A safety defect could exist in the transmission that could allow the rider to downshift from 1st gear into reverse without operating the reverse assist (lockout) lever. Unintended engagement of reverse gear while moving forward could lock the rear wheels and cause the rider to lose control. |
U.S. CPSC August 2, 2005 |
Kawasaki Motors Corp. U.S.A. Recall of ATVs A significant impact to the front wheel of the ATV while the steering is fully turned to either side can result in suspension damage, wear, and an eventual loss of steering control that could result in injury or death. |
U.S. CPSC November 13, 2008 |
Off-Road Motorcycles Recalled by American Honda Motor Due to Risk of Swing Arm Weld Failure The weld on the right side of the swing arm can fail, causing the rider to lose control and crash. This could pose a risk of injury or death to riders. |
U.S. CPSC December 22, 2009 |
Polaris Industries Recalls Certain ATVs Due to Crash Hazard The front suspension ball joint stem can separate from the steering knuckle and cause the rider to lose steering control, posing a risk of injury or death to riders. |
U.S. CPSC December 8, 2005 |
Kawasaki Motors Corp. U.S.A. Recall of All-Terrain Vehicles Tie rod separation caused by either wear or severe impact can occur during operation, causing the front wheel to separate from the steering control. Separation of the tie rod can cause the rider to lose control of the ATV, resulting in a serious injury or death to the rider. |
U.S. CPSC July 24, 2006 |
American Suzuki Motor Corp. Recalls All-Terrain Vehicles The mounting brackets used to secure the left-front suspension arm to the ATV frame may not have been welded completely and could break off during riding. If this occurs the rider could lose control of the ATV and crash, posing a risk of serious injury or death. |
U.S. CPSC March 14, 2005 |
Kawasaki Motors Corp. U.S.A. Recall of Kawasaki Prairie(TM) 700 ATVs The age recommendation warning label is missing. Children under 16 years old riding these adult-size ATVs can suffer serious injury or death. |
U.S. CPSC December 7, 2004 |
American Suzuki Motor Corporation Recall of 2004 & 2005 Eiger(TM) and Vinson(R) ATVs Recalled ATVs were assembled with an incorrectly sized mounting bolt under the fuel tank. This could result in fuel leakage presenting a fire safety hazard and risk of injury or death. |
U.S. CPSC December 29, 2010 |
American Honda Recalls Snowblowers Due to Fire Hazard The fuel tank joint and o-ring located on the underside of the fuel tank can seep or drip fuel over time, posing a fire hazard. |
U.S. CPSC November 8, 2007 |
American Honda Motor Corp. Recalls Lawn Mowers Due to Fire Hazard Due to a manufacturing defect, a crack can occur in the fuel tank causing a fuel leak. If gasoline leaking from the fuel tank is ignited, a fire or explosion can occur. |
U.S. CPSC June 21, 2006 |
American Suzuki Motor Corp. Recalls All-Terrain Vehicles for Crash Hazard If the cushion lever mounting bracket on the ATV frame breaks, the rider could lose control of the ATV and crash, posing a risk of serious injury or death. |
U.S. CPSC July 10, 2008 |
Lawn Mowers Recalled by American Honda Motor Corp. Due to Laceration Hazard The lawn mower's rear shield can break off allowing debris to be thrown toward the operator, which poses a laceration hazard to consumers. |
U.S. CPSC March 4, 2008 |
Polaris Industries Inc. Recalls ATVs Due to Risk of Injury to Riders A retention bolt can come loose causing the rear wheels to lock up, which poses a risk of serious injury to the rider. |
U.S. CPSC August 20, 2002 |
Arctic Cat Inc. Recalls All-Terrain Vehicles The ball joints on the front suspension of these ATVs can fail, resulting in a loss of control. This can cause the ATV to overturn, posing a risk of serious injury or death to riders. |
U.S. CPSC October 7, 2003 |
Kawasaki Recall of ATVs The lower front suspension arm can separate from the steering assembly, resulting in a loss of steering control and posing a serious risk of injury to the rider. |
U.S. CPSC June 20, 2007 |
ATVs Recalled by Polaris Industries Inc. Due to Fire Hazard The recalled ATVs may have a loose fuel valve within the fuel tank, which could cause a fuel leak and pose a fire hazard to riders. |
U.S. CPSC June 28, 2007 |
CPSC, Kawasaki Motors Corp. U.S.A. Announce Recall of All-Terrain Vehicles There is a risk of a fuel leak, which poses a fire hazard to consumers. |
U.S. CPSC April 29, 2005 |
American Suzuki Motor Corp. Recall of All-Terrain Vehicles The fuel petcock inserts were made with incorrect material that does not correctly bond the fuel tank and petcock insert, which could allow fuel leakage. If this occurs, a fire hazard with the possibility of injury and property damage could result. |
U.S. CPSC May 30, 2007 |
Polaris Recalls Select Hawkeye Model ATVs for Steering Post Failure Hazard The steering posts can break in the area where the handlebar attaches to the steering post. This can result in loss of steering control resulting in a crash and/or serious injury to the operator. |
U.S. CPSC May 3, 2007 |
Stateside Powersports Recalls to Repair 90cc Youth Model ATVs The ATVs lack adequate tire labeling, tire pressure gauge, adequate stop engine switch and other safety requirements which could result in injury to consumers. |
U.S. CPSC March 20, 2007 |
American Suzuki Motor Corp. Recalls All-Terrain Vehicles The bushing pivot mount boss on the left and right suspension arm may not have been welded completely and could break off during riding. If this occurs, the rider could lose control of the ATV and crash, posing risk of serious injury or death. |
U.S. CPSC March 24, 2005 |
Arctic Cat Inc. Recall of All-Terrain Vehicles (ATVs) The fuel tank used on some all-terrain vehicles could develop a fuel leak. If this occurs, a fire hazard with the possibility of injury and property damage could occur. |
U.S. CPSC March 9, 2006 |
American Suzuki Motor Corp. Recalls All-Terrain Vehicles for Fire Hazard Certain 2005 Eiger model year ATVs were assembled with an improperly manufactured plastic fuel tank. The thin portion of these tanks could develop a fuel leak, posing a fire hazard. |
U.S. CPSC February 14, 2008 |
Polaris Industries Expands Recall of ATVs Due to Fire Hazard The ATVs can have defective Electronic Control Modules (ECM) that overheat, posing a fire and burn hazard to riders. |
U.S. CPSC September 14, 2004 |
Polaris Industries Recall of ATVs The front brake lines can crack and leak brake fluid, possibly resulting in loss of braking capability. This could result in severe injury or death. |
U.S. CPSC March 29, 2005 |
Bombardier Recreational Products Inc. and BRP US Inc. Recall of DS650 ATVs The rear axle bearings may have not been sufficiently greased. This may cause a breaking of the bearing which could make the ATV unstable. The operator could lose control of the vehicle which could cause injury to the operator. |
U.S. CPSC December 19, 2007 |
American Honda Motor Corp. Recalls Lawn Mowers Due to Laceration Hazard The cutting blades could rotate under power when the control lever is released. The lawn mowers do not comply with mandatory federal safety standards for lawn mowers. The spinning blade poses a serious laceration hazard to consumers. |
U.S. CPSC February 10, 2009 |
ATVs Recalled By KTM North America Due to Brake Failure The rear brake caliper support can crack and the front brake operation can experience a loss of pressure, posing a risk of the rider losing braking and steering control and suffering injuries or death. |
U.S. CPSC March 10, 2011 |
American Suzuki Motor Corp. Recalls KingQuad ATVs Due to Fire Hazard Some KingQuad ATV's plastic fuel tanks were improperly manufactured and can develop a fuel leak, posing a fire hazard. |
U.S. CPSC October 22, 2007 |
ATVs Recalled By KTM North America Due to Brake Failure The rear brake caliper support can crack; this could result in the potential for a loss of the use of the rear brake and subsequently lead to an accident. |
U.S. CPSC June 26, 2008 |
ATVs Recalled By KYMCO Due to Loss of Speed Control A manufacturing defect in the carburetor can cause the throttle to stick open, posing a risk of serious injury or death to the rider. |
U.S. CPSC February 28, 2005 |
Kawasaki Motors Manufacturing Corp. USA Recall of ATVs On some units, the nut which secures the front upper suspension arm pivot bolt could come loose during vehicle use. Continued use of the vehicle could allow the nut to come off, and the upper suspension A-arm pivot bolt to back partially out. This would result in a loss of steering control, and possibly cause the rider to crash and suffer injury or death. |
U.S. CPSC June 23, 2011 |
American Honda Recalls Portable Generators The hazard labels attached to the batteries used on the generators are printed in Japanese instead of English. As a result, consumers handling the battery may not be able to adequately avoid risks associated with the batteries. |
U.S. CPSC May 30, 2007 |
Polaris Recalls Select Hawkeye Model ATVs Due to Loss of Control Hazard -- Three Crashes Reported The ATV's front bearing carrier can fail due to an insufficient amount of material thickness in the area where the lower a-arm and ball joint are attached which can result in a loss of control and a crash and/or serious injury to the operator. |
U.S. CPSC December 12, 2007 |
Outdoor Vacuums with Honda Engines Recalled By Billy Goat Industries Inc. Due to Fire Hazard The vacuum's fuel tank could crack and leak fuel. If gasoline leaking from the fuel tank is ignited, a fire or explosion can occur. This poses a fire and burn hazard to consumers. |
U.S. CPSC July 3, 2006 |
Bombardier Recreational Products Inc. Recalls All-Terrain Vehicles for Fire Hazard The operator could ride with their foot engaging the rear brake without noticing. This can cause the rear brake to overheat and possibly ignite, posing a risk of serious injury or death. |
U.S. CPSC April 29, 2010 |
Yamaha Recalls ATVs Due to Crash Hazard The steering column support assembly can crack and cause the rider to lose steering control, posing a risk of injury or death to riders. |
U.S. CPSC July 17, 2008 |
Log Splitter Engines Recalled By American Honda Motor Co. Due to Fire Hazard The engine's fuel tank can crack and leak, posing a risk of fire or explosion. |
U.S. CPSC September 9, 2004 |
Suzuki Recall of Four-Wheel Drive Eiger ATVs There are mislocated welds securing the upper front suspension arm mounting brackets to the frame. The mounting bracket could break off during riding, reducing rider control and resulting in loss of control of the ATV. Loss of control could result in a crash and severe personal injury or death. |
U.S. CPSC March 16, 2005 |
American Suzuki Motor Corporation Recall of 2004-2005 Vinson and 2005 KingQuad All-Terrain Vehicles (ATVs) Water can enter the throttle lever case and freeze, causing the throttle lever to become stuck and fail to automatically return to the idle position when the rider releases the throttle. If the throttle lever does not automatically return to the idle position when the rider releases the throttle, the ATV will not slow down as the rider expects. The rider could lose control of the ATV and an accident resulting in injury or death could occur. |
U.S. CPSC October 11, 2005 |
Bombardier Recreational Products Inc. Recall of All-Terrain Vehicles The drive pulley inner flange could break resulting in the broken flange fragments becoming a projectile. This situation could cause serious injuries or death to the rider or bystanders. |
U.S. CPSC June 4, 2008 |
Polaris Industries Expands Recall of ATVs Due to Fire Hazard The ATVs can have defective Electronic Control Modules that overheat, posing a fire and burn hazard to riders. |
U.S. CPSC September 6, 2007 |
Ohalee Inc. Recalls Youth All-Terrain Vehicles Due to Mechanical Hazards; Vehicles Could Put Young Riders At Risk of Injury These youth ATVs lack front brakes and a tire pressure gauge, the date of manufacture is not printed on side of the tires, and the front suspension is solid and does not allow for travel. |
U.S. CPSC November 16, 2010 |
Mini Tillers with Honda Engines Recalled Due to Fire Hazard A rubber grommet that is part of the engine's fuel tank may crack and leak fuel, posing a fire hazard. |
U.S. CPSC January 10, 2007 |
Kawasaki Motors Corp., U.S.A. Recalls 2007 KFX50 and KFX90 All-Terrain Vehicles On some of these units, the handlebar holder, tie-rod adjustment, and tie-rod end nuts may not have been tightened to the proper torque. Operation of the vehicle can cause the nuts to loosen, resulting in a loss of steering control. |