| Similar Articles |
|---|
 |
U.S. CPSC
August 5, 2008 |
DEWALT Recalls Cordless Brad Nailers Due to Injury Hazard The nailer can operate when the lock-off is in the locked position. Also, the nailer can operate when the trigger is not pulled and the contact trip is depressed. The unexpected ejection of a nail poses a serious injury hazard to consumers.   |
U.S. CPSC
June 3, 2005 |
DeWALT Recall to Repair Framing Nailers The contact trip on some of the nailers could malfunction and cause a nail to eject unexpectedly, posing a risk of serious injury to consumers. |
U.S. CPSC
December 21, 2006 |
DEWALT Recalls Cut-Out Tools Due to Shock Hazard The cord wire in these units could be damaged internally, posing a shock hazard to consumers. |
U.S. CPSC
April 29, 2008 |
DEWALT Recalls Table Saws Due to Laceration Hazard The pivot bracket on the saw can separate which can misalign the blade and the fence and cause kick back. This poses a laceration hazard to consumers. |
U.S. CPSC
June 21, 2005 |
DeWALT Recall to Repair Air Compressors Due to a wiring insulation defect, the unit may pose a possible shock hazard. |
U.S. CPSC
December 21, 2006 |
DEWALT Recalls Cordless Reciprocating Saws for Fire Hazard The switch on these saws can short circuit, posing a fire hazard. |
U.S. CPSC
November 8, 2006 |
DeWalt Recalls Framing Saws and Circular Saws for Laceration Hazard The lower blade guard can fail to close, leaving the blade exposed and presenting a laceration hazard to consumers. |
U.S. CPSC
December 20, 2007 |
DeWALT Recalls Cordless Drills due to Fire Hazard The trigger switch of the cordless drill can overheat, posing a fire hazard to consumers. |
U.S. CPSC
January 4, 2007 |
DEWALT Recalls Portable Generators Due to Electric Shock Hazard A ground fault circuit interrupter (GFCI) installed on the generator could fail to operate properly, posing a risk of electric shock to consumers. |
U.S. CPSC
June 29, 2006 |
Safety Alert: Porter-Cable Cordless Nailer Poses Puncture Hazard The nailer can eject a nail -- even while the switch is in the "off" position -- if the trigger is pulled and it is placed on a surface. This can pose a serious injury to consumers or bystanders. |
U.S. CPSC
March 11, 2010 |
Coil Nailers Recalled by Hitachi Koki Due to Serious Injury Hazard The nailers could have a faulty feeder that can allow nails to be ejected sideways, posing a serious injury hazard to the user or bystanders. |
U.S. CPSC
May 15, 2008 |
Fuel Cells Used With Framing Nailers Recalled by Paslode for Fire Hazard The fuel cells used to power cordless framing nailers can leak fuel, posing a fire hazard. |
U.S. CPSC
April 4, 2002 |
DeWALT Industrial Tool Co. Recall to Repair Circular Saws The spindle on the saw may slip, causing the blade to contact the lower guard, posing a hazard to the consumer from an exposed blade... |
