| Similar Articles |
|---|
 |
U.S. CPSC
June 25, 2009 |
DEWALT Recalls Framing Nailers Due to Serious Injury Hazard The bump action trigger on the framing nailers could have been incorrectly assembled during production, which would allow the nailer to eject a fastener unexpectedly or cause the trigger lock-off not to function. This can pose a serious injury hazard to the user or bystander.   |
U.S. CPSC
December 21, 2006 |
DEWALT Recalls Cut-Out Tools Due to Shock Hazard The cord wire in these units could be damaged internally, posing a shock hazard to consumers. |
U.S. CPSC
August 5, 2008 |
DEWALT Recalls Cordless Brad Nailers Due to Injury Hazard The nailer can operate when the lock-off is in the locked position. Also, the nailer can operate when the trigger is not pulled and the contact trip is depressed. The unexpected ejection of a nail poses a serious injury hazard to consumers. |
U.S. CPSC
December 21, 2006 |
DEWALT Recalls Cordless Reciprocating Saws for Fire Hazard The switch on these saws can short circuit, posing a fire hazard. |
U.S. CPSC
June 21, 2005 |
DeWALT Recall to Repair Air Compressors Due to a wiring insulation defect, the unit may pose a possible shock hazard. |
U.S. CPSC
April 29, 2008 |
DEWALT Recalls Table Saws Due to Laceration Hazard The pivot bracket on the saw can separate which can misalign the blade and the fence and cause kick back. This poses a laceration hazard to consumers. |
U.S. CPSC
January 4, 2007 |
DEWALT Recalls Portable Generators Due to Electric Shock Hazard A ground fault circuit interrupter (GFCI) installed on the generator could fail to operate properly, posing a risk of electric shock to consumers. |
U.S. CPSC
November 8, 2006 |
DeWalt Recalls Framing Saws and Circular Saws for Laceration Hazard The lower blade guard can fail to close, leaving the blade exposed and presenting a laceration hazard to consumers. |
U.S. CPSC
April 4, 2002 |
DeWALT Industrial Tool Co. Recall to Repair Circular Saws The spindle on the saw may slip, causing the blade to contact the lower guard, posing a hazard to the consumer from an exposed blade... |
U.S. CPSC
December 20, 2007 |
DeWALT Recalls Cordless Drills due to Fire Hazard The trigger switch of the cordless drill can overheat, posing a fire hazard to consumers. |
U.S. CPSC
May 15, 2008 |
Fuel Cells Used With Framing Nailers Recalled by Paslode for Fire Hazard The fuel cells used to power cordless framing nailers can leak fuel, posing a fire hazard. |
U.S. CPSC
March 11, 2010 |
Coil Nailers Recalled by Hitachi Koki Due to Serious Injury Hazard The nailers could have a faulty feeder that can allow nails to be ejected sideways, posing a serious injury hazard to the user or bystanders. |
U.S. CPSC
March 19, 2007 |
CPSC Launches "Drive to 1 Million" Recall Initiative Agency Stresses Search for Recalled Products during Spring Cleaning |
